Looking for a 250/300 intermediate flange

Sell your Stuff here
Post Reply
Message
Author
DEA
Posts: 97
Joined: Mon Jun 06, 2011 7:26 am

Looking for a 250/300 intermediate flange

#1 Post by DEA » Thu May 08, 2014 2:45 pm

crushed my pipe at Big Springs and broke the flange. any one have a used flange they would like to part with? this is for a 12 KTM 300 xc. but a 2007-current 250/300 will fit
Thanks Derek Albertson 816-213-9006
Thanks to Katie, Luke, Ali, and LETKO Cycles, Kenda, Amsoil, ODI, DT1, HBD Motographx, Dirt Tricks, Acerbis, Scott, AXO, Gaerne, Pivot Works, Vertex, Hot Rods, and Regina for the support. #215

User avatar
Pumpkinpatch
Posts: 272
Joined: Fri Jan 05, 2007 11:00 pm

Re: Looking for a 250/300 intermediate flange

#2 Post by Pumpkinpatch » Fri May 09, 2014 11:07 am

Not good Derek.
I had one of those trail tech flange protectors on the 2011 250 and never knew if it did any good or not.
Wondering now......$40 or $50 would be cheap insurance.
Mark Shafer
Rider #511 FMHSC
Proud Papa of #60 & #5

Thanks to #pumpkinpatchracing, Letko Cycles, MSR, EVS, DeCal Works, Atlas, 100%, Motorcare, HeavyD, DT1, Mika Metals

DEA
Posts: 97
Joined: Mon Jun 06, 2011 7:26 am

Re: Looking for a 250/300 intermediate flange

#3 Post by DEA » Fri May 09, 2014 12:32 pm

yea I had one of those on my 06 300. and never had any problems either, but I guess this will teach me not to ride with no rear brake again.....prob not. Tree 1- me 0. definitely didn't need the extra expense before the Nation Enduro.
Thanks to Katie, Luke, Ali, and LETKO Cycles, Kenda, Amsoil, ODI, DT1, HBD Motographx, Dirt Tricks, Acerbis, Scott, AXO, Gaerne, Pivot Works, Vertex, Hot Rods, and Regina for the support. #215

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests