FMHSC.com

Bike is ready to race!
Details:
Fresh top end, done by Motorcare
Suspension done by Leigh L. for a 160 lb. rider
New Dunlop MX51 on the rear
Front Bib Mousse
Full set of spare plastic:
Shrouds
Front Fender
Rear Fender/Side Panels
Hand Guard Plastic x2
Front Number Plate
Fork Guards
Spare air filter
Factory Brembo brake pads
Flatland skid plate
FMF factory fatty pipe
Stock 2.9 Gallon tank
New Battery and Starter Motor
Enduro Engineering Seat
Enduro Engineering Clutch Slave Cylinder Guard

NADA trade-in $3770, will take $3500 cash.
PM me for more information or questions!

This bike is as clean and fresh as I've seen one. Built to last for the next racer/rider.

Thanks Jeremy.

I meant to post on this also.
While in town last weekend; Jared and I went through the bike.

New rear tire. New rear brake pads ($$ factory Brembo pads), repacked the silencer, everything's clean straight, everything's tight. There is a full set of good plastic (not junk) and some other spares for the bike. All the manual is there and the factory tool kit.

The only thing we didn't get to yet is we felt a little (tiny) wiggle in the rear wheel bearings while cleaning things up.
We'll buy you bearings or if time, will also put in for you next time I'm in town.

If you feel the price is not where you think it should be; make us an offer.
I got the values from the current NADA book ("the" paper print book). Clean retail is over $4k. We are ok to take under trade, or a fair offer.
So, don't be bashful.

Thanks much.

If i had the cash itd be mine lol

Bump, At Letko Cycles for viewing!